How To Install A Radon Mitigation System In Sump Pump

How To Install A Radon Mitigation System In Sump Pump. These gases can enter your home through the footing drain tile that is connected to the sump pump in your basement. Cut it remove the whole thing replace the pump , put it all back together and put a rubber connector on the radon pipe.

Radon gas mitigation system with our PlumbStar USA sump from www.pinterest.com

This cover is designed to be gas tight and may also be used to retrofit failing sump basin covers. A sump pump cover may help to slightly reduce radon levels because it will block a major opening from the ground to your basement. This cover is good for passive mitigation and also has a hole for a radon pipe and discharge pipe built in to the center so you won’t have to drill your own.

It Keeps Their Properties Protected And Increases Its Value Even After A Couple Of Years Have Passed.

Ideally, the cover should be transparent or have a window through which the sump pit can be viewed. This will reduce radon exposure and be effective in a home with normal levels, but if the radon levels in your home are high, it may not be enough. The sump pump cover should be made of a durable material, such as abs plastic or acrylic glass.

A Lot Of People Believe That A Radon Mitigation System Is Run From The Sump.

Can radon come from the sump pump or pit? I chose to make a cut in my sump pump power cord(s), run them through a small piece of conduit, then splice them together again inside a conduit box. If the sump pump cannot be unitized as a suction point, it will need to be sealed so the radon cannot seep into the home through the opening.

The Process Of Sump Pump Installation Consists Of Cutting The Concrete In A 24X24 Square, Excavating The Dirt, Installing The Pit, Backfilling With Pea Gravel, And Pouring A Little New Concrete For The Finishing Touch.

A sump pump cover, if well installed, helps in minimizing radon levels. And one of the ways it does so is by finding its way through a leaky sump pump. Cut it remove the whole thing replace the pump , put it all back together and put a rubber connector on the radon pipe.

Below Is A List Of The Parts I Used And A Time Line Of The Video:radon Fan.

Sump pump radon system vs drain tile radon system here at lifetime radon solutions, we often get asked how we can run the pipe of a radon system from one end of a house to another. It takes about 2 days to get a reading. A sump pump cover may help to slightly reduce radon levels because it will block a major opening from the ground to your basement.

The Long Term Reading Is A 7 Day Reading.

For more detailed instructions visit. However, covering your sump isn’t enough, especially if radon levels in your basement are high (at or above 4.0 pci/l). The sump pump is not the only point.