How To Stretch Chain Link Fence Tension Wire. Prepare to tighten chain link material. Take your pliers (lineman pliers work best) and grab the tension on the wire with pliers or one of the terminal posts.
Attach fence tighteners and twist them with a pair of pliers to pull the wire tight again. At every line post, tie the tension wire to the line post with a fence tie. By mastering this lesson, you will be a
Table of Contents
Install The Chain Link Mesh.
Then attach a stretcher bar to the tension bar. Once tension wire is stretched, walk along fence line and tuck the bottom tension wire under, then between the posts and the chain link fabric. Place your wire dog approximately ten feet from the terminal post.
It Secures The Bottom And Top Of Your Chain Link Fence To Ensure The Chain Links Remain Tight To The Posts And Rails.
Discharge the cable so that the cable hook is wrapped around the middle (height) of the terminal post. Also, put in place the tension bar at the bottom tension band of the pole. Super easy, make a tightening tool utilizing a piece of scrap pipe i used 1 1/4 pipe with a 1/4 hole drilled 1 1/2 from the end , and then drilled out a 5.
What Is Tension Wire Used For On A Chain Link Fence?
If installing top tension wire, you will thread the wire through the loop caps. As you are basically attempting to straighten metal, you may find it nearly impossible of getting out every bend and ripple manually. If installing top tension wire, you will thread the wire through the loop caps.
The Wire Is Thick, Heavy, And Is Difficult To Stretch.
The common wire used as bottom tension wire on chain link fencing is a 9 gauge galvanized wire. 3) chain link fence stakes. Cut your tension wire and attach to the end band located at the base of the terminal post.
At Every Line Post, Tie The Tension Wire To The Line Post With A Fence Tie.
By mastering this lesson, you will be a 2) use cinder blocks or allan blocks to fill the gap at the bottom of fence. Tension wire is an important part of chain link fencing.